The LNER Encyclopedia

Hello everyone.

I'm looking for Graeme King resin parts for an A2/1 that I'm building. I've looked around online as to where I can buy the parts and I'm told that I can get in contact with Graeme on this website and purchase the parts. I am rather new to this website, does anyone know if these parts are these parts still for available? And if so how much do they cost?

Any help would be appreciated. Thank you.

Graeme is a member of the site, but he is in sunnier climes at present, sipping a fancy cocktail while being fanned by a harem of nubile women.

No doubt he will respond when he recovers.

Not if his wife finds out, he won't.

I have no doubt she's on the next recliner along with bronzed and oiled Adonii pandering to her every whim.

Hello Alex, I'm back!

I'll send you a private message via this forum in due course, containing my e-mail address, although I'm not sure whether you'll need to post a few more entries on the forum before you are able to get access to the PM. Once I have your e-mail address too, I can send you full details. Publishing e-mail addresses on the open part of the forum isn't a good idea, for obvious reasons. Equally, the PM system has to be restricted to limit the ability of robots to send rubbish to all forum members.

If you want the information more quickly and you can "de-code" an e-mail address sent out in the characters of the NATO alphabet, I can try that instead......

Graeme King

I think he'll be able to read your PM but not reply until he has had the usual 5 posts approved.

Richard

Hi,
Thanks I'll check my messages and send an email.

Received, and informative response sent.