Page 1 of 1
Cleaning Brass pickups
Posted: Wed Feb 08, 2006 2:03 pm
by daveinstoke
years ago I started an 04 k's kit . ( 35 years ago !) finaly took it out of the box to finish & ola the brass hass gummed up. what is there solution wise to clean the brass pick ups & the inside of the wheels. The motor turns fine with a direct current application. I was thinking about Lemmon juice to clean , but has anyone any better thoughts.
Dave.
Posted: Wed Feb 08, 2006 2:53 pm
by LNERandBR
try using nothing but the trusty fiberglass pencil.
A bit of rubbing of one of those will bring back the shine and the electric connectivity.
Posted: Thu Feb 09, 2006 5:58 pm
by 50A
Dave.
Watch out for those pesky fibres getting in the motion and gearbox. Fibreglass brushes are great for bodywork. Cotton buds dipped in methylated spirit might help in the wheels and pickups - don't get them too wet though.
Hope this helps.
Andy
Posted: Thu Feb 09, 2006 7:59 pm
by richard
Yes, here in the US you can buy "Microbrushes" which are like tiny cotton buds but the bristles are attached (like a toilet brush!). I use these with wheel cleaner (typically somekind of spirit).
A lot of stores have them in packs of 10, but MicroMark have them in packs of a hundred. (I've also found them useful for fine painting, and removing numbers from locos)
You'll be surprised by the amount of dirt that comes out.
Richard